Replace Stereo Wiring Car. This wire provides power to the dashboard lights so they can be turned on when the car is. Web to get back to the procedure:
Ground Wires and Install Your Own Car Stereo from www.thoughtco.com
Take a look, just in case, that the harness is the same and that it fits into the slot of the radio. There should be at least one connector, or wiring. Web looking for a stereo or accessories for your vehicle?
Web Looking For A Stereo Or Accessories For Your Vehicle?
The bracket and the space in the dash are. There should be at least one connector, or wiring. Web to get back to the procedure:
Pull The Factory Stereo From The Dash And Disconnect.
Remove the negative battery terminal. Take a look, just in case, that the harness is the same and that it fits into the slot of the radio. Web turn the car off, remove the key, and pop the hood.
Web In The Vehicle Pictured Above, The Factory Stereo Is Connected To A Large Bracket That Includes A Storage Pocket.
Let cool and test the solder job by tugging on. Remove the stereo’s cabin paneling with the pry tool. After pulling the stereo unit forward, you should see it is wired inside the dashboard.
Pull The Factory Stereo From The Dash And Disconnect.
There are three main issues that you can run afoul of while replacing your own head unit: Connect the new car radio. Web the biggest pitfalls of diy head unit installation.
Web Pulling Out The Old Stereo.
This wire provides power to the dashboard lights so they can be turned on when the car is. Web the orange wire on a aftermarket car stereo is the illumination wire. Web using a soldering iron or a soldering torch, heat the wire and feed in your solder slowly until it absorbs into the wire.
/GettyImages-894436446-5c69ef4346e0fb0001560d48.jpg)
